@supercat Thank you for the heads-up. I’ve seen that bug before but I don’t know what causes that. I just recompiled and reuploaded this module with the newest modkit. Please test and let me know.

most wires are visually offset in the right eye when playing in vr.

@starwolf3325 This module does not have bugs that obvious. We’ve played it hundreds of times without such a problem. My guess is that you misunderstood something about the rules. Take another careful read through the manual and let me know if anything is unclear :)

I've had a few bugs on this one. I get a strike when I'm on step J/W and cut the wire when the previous wire is not one of the ones listed.

Tried, pretty hard, but doable. It does cost a decent bit of time though, so if you have 2 or 3 of these, you better have some serious time left. Well made.

do you mind to put up a german version?

Right now I cant figure this out

im getting this right now coolest module ive seen so far

@caisith2: I recently practiced the module and get it now, thanks.

See that black wire going from 7 to 9, and the Yellow wire going from 8 to 10 in the example picture? What is common between the two of them, is they both skipped a position, 6 and 9 respectively. This means if you were on the white wire going from position 7 to 8, and the instruction is "Cut if the previous wire skipped a position", you would cut it. Like wise. If you were on the yellow wire going from 8 to 10, with that same instruction, then you don't cut it.

What does it mean for step I or V "Cut if the previous wire skipped a position?" Is it where like if it is connected from 2 to 3, I don't cut? (Haven't tried this just yet.)