Stormworks: Build and Rescue

Stormworks: Build and Rescue

SBS HERMES Mk.I Medium Transport Plane (LEGACY)
Showing 1-10 of 23 entries
< 1  2  3 >
Update: 26 Mar, 2019 @ 1:29pm

Updated SBS HERMES Mk.I Medium Transport Plane.

Update: 26 Mar, 2019 @ 9:08am

Updated SBS HERMES Mk.I Medium Transport Plane.

Updated Paint Job so that it reflects the old scheme used by the Canadian Forces Search and Rescue Group.

Update: 26 Mar, 2019 @ 8:46am

Updated SBS HERMES Mk.I Medium Transport Plane.

Update: 25 Mar, 2019 @ 11:20pm

Updated SBS HERMES Mk.I Medium Transport Plane.

Removed DROP REQUEST AP MODE Consideration. Running out of Space and Time. Moving on to new project.

Change Colour of Vessel to White and Orange for basic Grey.

Removed WIP. Considering current version final for systems. May be minor tweaks to AP, etc. but not planning on adding anything additional.

Update: 25 Mar, 2019 @ 10:56pm

Updated SBS HERMES Mk.I Medium Transport Plane. Renamed vehicle from "SBS HERMES Mk.I Medium Transport Plane (WIP)" to "SBS HERMES Mk.I Medium Transport Plane".

Update: 23 Mar, 2019 @ 10:46pm

Updated SBS HERMES Mk.I Medium Transport Plane (WIP).

Update: 23 Mar, 2019 @ 7:44pm

Updated SBS HERMES Mk.I Medium Transport Plane (WIP).

Removed the Automatic Return to Zero Pitch in flight. It was somewhat counter-intuitive for flying. The plane will now work to maintain the pilot designated pitch angle when not in Hold Altitude mode.

Upped the starting Engine Throttle to 20%. Idle Mode is still set to on by default and should be used when sitting still, slow taxing or settling the engines down after land. At 20% throttle when Idle Mode is off it will give a good amount of speed for quicker taxing.

Update: 20 Mar, 2019 @ 10:12pm

Updated SBS HERMES Mk.I Medium Transport Plane (WIP).

Update: 20 Mar, 2019 @ 9:51pm

Updated SBS HERMES Mk.I Medium Transport Plane (WIP).

Update: 20 Mar, 2019 @ 7:58pm

Updated SBS HERMES Mk.I Medium Transport Plane (WIP).

Added an enhancement to Autopilot where you can apply additional Yaw and Roll manually in addition to what the plane's system is adding. I found it useful for when I line up the plane for what I assume is a straight line run on the runway only to be slightly off to the left or right. Now I can provide some "push" to move the plane to where I need it to go while it's still in AP and the AP will work with that in order to reallign it so that it's moving again towards the WP after the push is removed.

Some additional clean-up on some controls and instruments.