Subscribe to download
R.U.S.T. Harvester

The rear wheels keep breaking off, even when harvesting.

@jackattack
1:another level designer and me worked on the campaign. so you could say we created it together.
2: two reasons, I honestly did not intend them to be from the R.u.s.t. faction and because nearly all of those ships were designed for looks in the campaign. but their function is quite terrible. they have no interiors etc.

Two Questions?
1. For The Champaign Did You Create The Corporate ROS4 Faction, Or Was It Another Person from KSH
2. Why Have not all the Good R.U.S.T. Ships Released Yet, For Example The Rebel Dropship mk.1
Thankyou

@jackattack
its a long time ago. I think it was a tiny factory from where the harvesters could opperate. but it was not a finnished or funtional base as far as I remember.

On The First Screenshot What Is The Building In The Distance?

@Hun7er
the rear wheels are attached to rotors. not actual suspensions.
this is so I can make the car drive by itself on a low pace.
normal wheels can be stacked.

What wheels are used as rear wheels ???

Nice one! I will use this in survival mode. One question: How do I lock the wheels at an angle to make it go in circles automatically?

@bigbadvoodoodady_1
You can use this on multiple ways. when you sit in the pilot seat, activate the timer block to make the harvester slowly move forwards and mine by itself. it works on ice lakes only.

you can program the remote controll by giving it a coordinate where it is supose to stop(might have to increase the gyroscopes power) , and set the remote controll action to trigger the time so that the harvester stops at the coordinate.

you can set the antenna in te timer so you will know when it is done.

or, simple start the timer block again so that the harvester will stop after a couple of minutes / hour. it will drive forwards or in circles if you set the wheels in an angle.

hope this helps.

Argath please explain your most recent post... is this a turn-key solution, or do I have to program the equipment to go into autopilot? Will it automatically drill on lake beds? Or do I have to give coordinate and it just goes and sits there and waits? How does this work?