Halaman Toko
Stormworks: Build and Rescue
Semua Diskusi Screenshot Ilustrasi Siaran Video Workshop Berita Panduan Ulasan

Stormworks: Build and Rescue

Halaman Toko
Stormworks: Build and Rescue >  Workshop > Workshop Uran_Wind
Tidak cukup rating
ZE Train Wheels Antislip
Deskripsi Diskusi0 Komentar17 Catatan Perubahan
   
Penghargaan
Favorit
Difavoritkan
Batalkan favorit
Vehicles: Land, Mechanical
Microcontrollers: Microcontroller
Tag: v1.11.0
Ukuran File
Diposting
Diperbarui
47.210 KB
2 Mar @ 8:03am
11 Mei @ 7:21am
2 Catatan Perubahan ( lihat )
Dibuat oleh
Uran_Wind
Offline
Lihat semua koleksi12 (beberapa mungkin disembunyikan)
1,091 Pengunjung Unik
686 Pelanggan Saat Ini
20 Favorit Saat Ini

Berlangganan untuk mengunduh
ZE Train Wheels Antislip

Deskripsi
  • A controller that prevents wheels slip for trains powered with electric motors while accelerating or decelerating.
  • Requires the linear speed sensor and the torquemeter, installed right before the train wheels assembly.
  • Has an optional antislip for the brakes and controls it independently of the motors throttle. If you don't need this feature for brakes, ignore or remove corresponding nodes.
17 Komentar
< >
Uran_Wind  [pembuat] 10 Sep @ 6:07pm 
Train wheel assembly x3 has the same wheel grip as the x1, it is better to use three of them instead.
Echoless 10 Sep @ 5:12pm 
I'm using the Train Wheel Assembly x3, and there is still a ton of wheel-slip at max sensitivity
m4tik 10 Jun @ 1:40am 
I have similar problem like "Nick Name". accel sensitivity 1 its a little better, but with heavy cart im very slowly get to 15km/h. But by hand i can get 20km/h without slip and a lot faster.
Nick Name 11 Mei @ 1:22pm 
via xml sure, whats your disc?
Uran_Wind  [pembuat] 11 Mei @ 1:10pm 
You can send me your train via workshop or xml, maybe i will find out why it is so slow.
Nick Name 11 Mei @ 12:48pm 
the input speed is directly from the linear sensor, and it is after any gearbox, directly on the wheels
Uran_Wind  [pembuat] 11 Mei @ 12:18pm 
I updated the controller and reduced the slider multiplier, so now it should be even smaller on sensitivity 1. Also, check if the torquemeter connected to the wheels directly without any gearboxes, and if the input speed is in m/s.
Nick Name 11 Mei @ 11:49am 
I've done so all the way to 1, acceleration becomes a slight bit better, but still alot worse, takes me ages to get up to 30ish mph, when i could get up to 120 without it
Uran_Wind  [pembuat] 11 Mei @ 7:14am 
Try to reduce the antislip sensitivity slider.
Nick Name 11 Mei @ 6:43am 
the only issue i have with this, is on heavier train the wheel tends to sleep a tiny bit when accelerating, they rotate faster than the train they're on, but don't actually slip, your controller doesn't seem to account for that for me, meaning it greatly criples it's acceleration