訂閱以下載
Large Modular Ship Set - Free to Use

Large Modular Ship Set - Free to Use
[PLEASE USE THE LARGE WORKBENCH]

Prebuilt Sections:
-----------------------
3 Bows (Cargo, Military, Civilian)
2 Sterns (Single Propeller/Rudder, Duel Propeller/Rudder)
1 Customizable Mid-Section
3 Bridges (Cargo, Military, Civilian)
4 Utility Racks
3 Funnels (Vertical, Angled, More Angled)
3 Masts
4 Large Diesel/Electric Engines
46,000 unit Fuel & Stabilizer Pack
Controllers
and Decor
------------------------

Both Bow and Stern sections have Pivots below the waterline to help with buoyancy installed already.
Control Surface Stabilizers are installed below the Mid-Section already

[Guide to building with Modular Hulls]
https://steamproxy.net/sharedfiles/filedetails/?id=3205598500

[Building]

1. Copy the section you want to use and paste it into a new creation.
2. Align using the BOTTOM of the hull.
3. The middle section is meant to be tapered to your desired length.
4. Merge Sections together.
5. Add Fuel and Stabilizer Pack directly under the center of mass.

[IMPORTANT]

1. Fuel and Stabilizer Pack needs to align with the bottom of the hull. You will delete the existing blocks with the Fuel and Stabilizer pack as meant to.
2. Align the Blue cross under your center of mass after you connect the sections you want. This will help keep your center of mass but also provide the most stability.

[LOGIC]

1. Connect your "A/D" to the bow thruster electric motor, and the clamp above the rudders for steering.
2. The Linear Speed Sensor needs to be installed in the furthest rear wall facing forward. (Control Surface Stabilizer)
3. The throttle needs to be connected to both the Large Engine throttles and the Large Electric Engine throttle.
4. Place one Tilt Sensor at the highest point on the ship, facing left. (Both the PID in F&S Pack under the Process variable and the Altair Stabilizer(CS Stabilizer))


Any credits are appreciated but not necessary

RIS Soldier