Subscribe to download
Frog Industries Coastal Lander L1-A

---

NOTE: This craft was built for Captain's Build Challenge Foxtrot.
Bernoulli Novi, an Aviation, Logistics, & Arms Corporation, was in need for a light and simple vessel to transport "small" cargo. They turned to the local industrial conglomerate Frog Industries to see this need fulfilled.

A small water jet driven craft was provided, and after testing, Bernoulli Novi was satisfied with the early results and invested in it's development. The Coastal Lander L1-A was, as per the request of Bernoulli Novi, equipped with a small personal defense gun mounted in a "Crow's Nest". The lander had sufficient handling capabilities from it's two water jets that maneuvering in and out of harbors and to coastal landing sites was no issue.

---

The L1-A is a small dual water jet driven Landing Craft "capable" of fitting an ISO container as cargo (However this is not advised due to excessive weight). The vessel comes in at a cost of just over $37,000. NOTE: Frog Industries Insures Assures That No Cost Saving Corners Were Cut.

Seat Controls:
W/S.......................Forward/Backwards
A/D........................Steering (capable of turning in place)
UP/DOWN.............Raise or lower seat
1............2nd Gear
2............3rd Gear

Ramp Controls:
The Ramp can be operated from both the cabin and on the deck.
2 Panels control the ramps extension and retraction.
NOTE: The winch holding the outer section of the ramp might need to give out more rope or the ramp will not fold out correctly!

Crow's Nest Controls:
W/S..............................................Aim Up/Down
A/D...............................................Aim Left/Right
Up/Down......................................Zoom Camera
Space Bar[Trigger].....................Fire Gun
1...................................................Toggle IR Camera Mode

To Operate Vessel
To start the Lander:
1. turn the key labeled "Activate".
2. Increase engine RPS by adjusting the throttle lever.
3. Once rps has stabilized, engage the clutch for the water jets. YOU WILL NOT BEGIN MOVING!
4. Use W/S & A/D to move and steer the vessel.
NOTE: You can decrease the clutch to get rid of the water effect when propulsion is not needed.

To Operate Ramp:
Use Panels to extend outer ramp,
lower inner ramp until contact with ground,
adjust until desired angle of ramp is reached.
It might be necessary to adjust the winch length to allow the outer ramp to behave correctly!

---

Lorgs Water Jets Controller
https://steamproxy.net/sharedfiles/filedetails/?id=2171285637

Uran_Wind's ZE Modular Engine Controller
https://steamproxy.net/sharedfiles/filedetails/?id=2416132817