상점 페이지
Stormworks: Build and Rescue
전체 토론 스크린샷 아트워크 방송 동영상 창작마당 뉴스 가이드 평가

Stormworks: Build and Rescue

상점 페이지
Stormworks: Build and Rescue >  창작마당 > Sketch 님의 창작마당
73 평점
Frontier Oil | Inland Oil Rig | OUTDATED/BROKEN
설명 토론0 댓글57 변경 내역
   
어워드
즐겨찾기
즐겨찾기됨
즐겨찾기 해제
Vehicles: Vehicle, Technical, Land, Mechanical, Stationary, Structure, Advanced
태그: v1.7.2
파일 크기
게시일
업데이트일
4.113 MB
2023년 3월 20일 오후 6시 18분
2023년 4월 12일 오전 10시 44분
변경 사항 4개 ( 보기 )
제작자
Sketch
오프라인
모음집 106개 모두 보기 (숨긴 상태 몇 개 있을 수 있습니다)
14,548 순 방문자 수
8,420 현재 구독자 수
145 현재 즐겨찾기 수

다운로드 위해 구독하기
Frontier Oil | Inland Oil Rig | OUTDATED/BROKEN

설명
Spec Sheet

Maximum Crude Oil Storage
115686 Liters / 30561.1 Gallons
Maximum Slurry Storage
144558 Liters / 38188.3 Gallons
Maximum Drill Speed
2 Rotations Per Second

RIG MANUEL

Drilling:

1. TO LOAD A ROD, Take a rod out of the rod storage rack on the left side of the platform. Slide the rod out and over the outer railing and grab the end of the rod and place in the arm clamp.
2. Navigate to the panel next to the drilling darrick and turn on the "Arm Clamp" and "Drilling Darrick Clamp" keys. The rod may need to be moved around a bit but It will then lock into place
3. Navigate to the control room and turn the "Panel Power" key and press and hold the button labeled "Pump Jack Up" and turn on "Turntable Clamp".
4. Once the Pump Jack reached the top of the drilling darrick head back towards the rod loading station.
5. Move the rod backwards to the tip of the rod is aligned with the edge of the arm clamp.
6. Press "Tip Rod" and the rod will move horizontal towards the drilling darrick.
7. Push the rod down into the turntable until it locks.
8. Head back up towards the control room and turn on "Pump Jack Clamp" and move the pump jack down until it locks to the rod.
9. TO START DRILLING, Turn on "Slurry Pumps In" and "Slurry Pumps Out" and press "START DRILL".

Connecting More Rods:

1. After the rod is in the connecting area of the drilling darricks slider. (REVERT to steps 1-6 in part 1 of now to load another rod)
2. An indicator will turn on labeled as "Rods Aligned" will illuminate and the "Connect New Rod" button can be pressed to lock the new rod into place.

If you are having trouble connecting another rod:

When the pump jack makes it to the drilling darricks clamp when drilling DON'T STOP the drill! For some reason if the pump jack stops the well still gets deeper! After the well has stopped increasing it's depth, you can disconnect the swivel clamp and and the turn table clamp and move the rod down far enough for a new rod to be connected. I'll of course tune this when I get the chance to.

Patch Notes:
-Changes to structure
-Moved controls by the drilling darricks panel
-Improved rod connection issues.

Credits:

Sawyer News: https://steamproxy.net/profiles/76561198443297702
Fluorescent Light Fixtures: https://steamproxy.net/id/bassalicious
Thumbnail: https://steamproxy.net/profiles/76561198311631787

The Frontier Discord Server
https://discord.gg/MSg25NqZZr

If there is any questions, comments, concerns, please post them in the comment section below.

Sketchest © | Frontier Oil Company ©
댓글 57개
< >
Arty likes farty 2023년 8월 7일 오후 3시 50분 
same everything is working but my tanks arent filling
Firek1d77 2023년 6월 27일 오후 11시 19분 
why is it not collecting oil? someone help
43D3R41K 2023년 6월 24일 오후 7시 24분 
a very good drilling rig. it would not hurt to add a platform and guides for the rod on the loading clip, and so everything is super
:steamthumbsup:
griffinrider1812 2023년 6월 24일 오후 3시 44분 
@average IED enjoyer I would assume so, because you can spawn guns and such without the weapons DLC, you just can't shoot them. So what I think will happen is that you can use it but you won't be able to collect any oil or anything with it
bensmothers09 2023년 6월 22일 오후 11시 02분 
@doc yes it is takes like 15 minute for each rod when i try, an arm takes like 30 seconds
Doc 2023년 5월 24일 오후 3시 38분 
@Mr. Glitch It's really not that hard to use our hands
tacticalcatboy 2023년 5월 23일 오전 11시 40분 
can you add like remote control functions, so like you can control the control room stuff from below
Mr. Glitch 2023년 5월 21일 오후 4시 25분 
Excuse me, I don't see an arm for grabbing rods nor controls for them. Do not tell me we are supposed to use hour hands to grab rods.
avarage IED enjoyer 2023년 4월 23일 오후 2시 10분 
hey can i spawn this in without the industrial frontier dlc?
The FemBurber 2023년 4월 9일 오후 3시 05분 
mr noodles try just turning off the clamps, it will fall naturally.