Winkelpagina
Stormworks: Build and Rescue
Alles Discussies Screenshots Beeldmateriaal Uitzendingen Video's Workshop Nieuws Gidsen Recensies

Stormworks: Build and Rescue

Winkelpagina
Stormworks: Build and Rescue >  Workshop > Workshop van Phil
31 beoordelingen
Smooth RPS Limiter (Modular Engines and Prefabs)
Beschrijving Discussies0 Opmerkingen30 Wijzigingen
   
Prijs
Toevoegen aan favorieten
Toegevoegd aan favorieten
Verwijderen uit favorieten
Vehicles: Air, Sea, Land, Mechanical
Microcontrollers: Calculation, Fluid, Modular, Microcontroller
Tags: v1.2.3
Bestandsgrootte
Geplaatst op
Bijgewerkt op
164.550 KB
13 jun 2021 om 13:00
13 jun 2021 om 13:21
2 wijzigingsnotities (weergeven)
Gemaakt door
Phil
Offline
Alle 20 verzamelingen bekijken (sommige zijn mogelijk verborgen)
2,684 unieke bezoekers
1,327 huidige abonnees
30 huidige favorieten

Abonneren om te downloaden
Smooth RPS Limiter (Modular Engines and Prefabs)

Omschrijving
If you are unhappy with the 0.5 method consisting in cutting the throttle in half if the RPS are above the set limit, try out this Microcontroller! (No PID inside!)
With this smooth approach you can get a more continuous engine throttle resulting in less fuel consumption and heat generation as well as less unpleasant engine noise.

You can enable variable RPS limit to change that limit in-game while on the move.
A hardness factor is determined by your set RPS limit to keep the resulting RPS from overshooting more than 1. You can manually increase that factor if you want to be closer to the RPS limit.

This controller works on no load engines too but is meant for engines under load like vehicle engines.
30 opmerkingen
< >
Phil  [auteur] 3 jul om 7:12 
Throttle is throttle, you need to add fuel manifold throttle which without supercharge can just be half of the air throttle.
CatLover2500 2 jul om 13:34 
Does it work with modular engines?
__MRX__ 31 mrt om 6:20 
you should add idle rps
Firegecko 14 dec 2023 om 0:16 
Awesome. Just what i was needing. Thanks heaps!
Decadenced 6 aug 2023 om 10:25 
works fine 4 me, thank u
Phil  [auteur] 28 jun 2023 om 9:56 
No it doesn't, just an RPS limiter like the name says, not an ECU. To idle engine you could just switchbox to a PID with P of 0.3.
buder28 27 jun 2023 om 14:16 
that mcu dosent have any kind of idling controll last time i tested
you will need to figure that out
Ninovium 27 jun 2023 om 13:39 
btw if you connect an actual throttle to the controller, then the engine just goes to 1 rps and dies. If you connect to W/S, it revs the engine to the max until it explodes. (it also implodes your ear drums)
Ninovium 27 jun 2023 om 13:37 
I have the same problem as the guy below, could you show us how to actually connect it? (to help idiots like myself)
BasicallyIPlayGames 8 jun 2023 om 20:47 
Other than its set up with W/S but I'd imagine it should still work set up like that still.