Subscribe to download
SEPECAT Jaguar A

The SEPECAT Jaguar is an Anglo-French jet attack aircraft originally used by the British Royal Air Force and the French Air Force in the close air support and nuclear strike role. It is still in service with the Indian Air Force.
Wikipedia[en.wikipedia.org]

---

• Flight control system. (View control, stabilization, auto pilot, landing assistance)
  
• HardPoint System compatible with all payload.
  
• 1:1 Scale.
  
• Transponder.
  
• Air Pressurce controlled PID (for smoother acceleration/deceleration).
  
• Radio equipment.

• Top speed 579 km/h.
  
• Stall Speed 200km/h (Flaps 9).
  
• Fuel: 6022L (3922L Internal + 3 * 700L External Tank).
  
• Range: 120km+ (with external tank).
  
• Gun: 2 Light autocanon (200 munitions)
  
• Hardpoinst: 3 Electric/Fluid connector + 2 Electric Connector.
  
• Afterburn: Yes.
  
• Seats: 1 Pilot + 8 decorative passager seat.

The engine is weak at low power, push the throttle to 50% to start moving.
But keep the throttle below 12% (The first HUD line) to drive.

Disable brakes, pitch up, full throttle and here we go.

- Enable the flight control system and click on "landing". It will automaticaly set the throttle to stay at a low speed.
You can use up/down to increase/decrease the target speed.
- Drop the landing gear (left pannel).
- Press 6 to open air brakes.
- Drop flaps to 9 and drop landing gear.
- Ajust the pitch to get smoothly to the ground.
- The jet will stop by itself.

STAB = gyroscope
APLT = auto pilot
AALT = auto altitude
LANDING = look after

Click on > to have more control/info

You can save multiple waypoint (x,y,altitude) on the autopilot. the auto altitude will follow the altitude saved in the autopilot. If no waypoint are aviable the autopilot will use the values from the keypads.

Click anywhere to center the map on the clicked coordinate.
Click on + to zoom in.
Click on - to zoom out.
Click on c to recenter the map on the transponder coordinate.
Click on ! to enable/disable the transponder (it will not send data but still receive them)
See the link below for more details.

You can select 2 type of payload at the same time, press the I or II button to change one of them. Press 1 or 2 to drop them.
To select any type of payload use the middle left/right arrows (Only aviable payload are selectable).

You can select a single hardpoint connector using it's ID (from 1 to 7 starting to the left). If the system is not armed pressing 2 will drop the payload. If the system is armed it will launch the hardpoint.

This system will automaticaly select which hardpoint will be launched next.

The "CTR" button will be enabled by controlable payload (camera, winch etc...). The system will show a video created by the payload and will send to it where you click on the display.

• The plane will pitch down when fully loaded.
  
• The front landing gear can failed during hard landing.
  
• The batterie will be used a little even with electric breaker turned off.
  
• Sometime landing gear can jam themself.

• HUD (original): https://steamproxy.net/sharedfiles/filedetails/?id=2136926352
  
• Transponder: https://steamproxy.net/sharedfiles/filedetails/?id=2463909871
  
• Hardpoint: https://steamproxy.net/sharedfiles/filedetails/?id=2604916168