Subscribe to download
Titan M4000 [Mobile Crane]

Mid to Heavy Duty, Extremely Capable, Requires Expert Operator


Multi cranes lifts with a single operator
Approx. 80m Boom
Safe working load of approx. 25t
Max Lift approx. 35t
Diesel Electric
Wind Speed warning
No Mods

10t, 20t and 30t Counterweight
https://steamproxy.net/sharedfiles/filedetails/?id=2281809052
https://steamproxy.net/sharedfiles/filedetails/?id=2281809547
https://steamproxy.net/sharedfiles/filedetails/?id=2281809771

20m, 30m and 50m M Series Fly
https://steamproxy.net/sharedfiles/filedetails/?id=2281810013
https://steamproxy.net/sharedfiles/filedetails/?id=2281810348
https://steamproxy.net/sharedfiles/filedetails/?id=2281811364

Collection:
https://steamproxy.net/sharedfiles/filedetails/?id=2293207282

Setup with the Y Boom Guying System:
When extending the boom the Guying Cable must get sent out at the same time, once the boom is fully extended send the Guying Cable back in till the "Guys" are in a vertical position (should happen automatically once there's enough tension), Then use the throttle lever to adjust the Y position.

Connect 2 or more cranes:
Set the master crane (the one your going to operate) Local and Remote radio freq to 1 and set Remote control to 1 on the other crane/s but leave the Local control at 0.

Using/Attaching the Fly Jib: https://youtu.be/7MLDfVnFk0A
Position the crane over the jib, lower the main winch as not to interfere when lifting the jib on to the boom, once in position use the secondary winch to lift it on to the connectors on the boom.

Using 3 and 4 will move it up/down.

Note: Freq must be set to 0 for the Jib to work.

If the boom doesn't extend exit to the main menu and load back in
Velocity pivot randomly starts moving while driving (sharp turns) exit to main menu and load back in

Shoutout these lads:

Enigne Key
https://steamproxy.net/sharedfiles/filedetails/?id=1656926848

Door Controller
https://steamproxy.net/sharedfiles/filedetails/?id=1875903150


Please don't re-upload without permission