Installer Steam
connexion
|
langue
简体中文 (chinois simplifié)
繁體中文 (chinois traditionnel)
日本語 (japonais)
한국어 (coréen)
ไทย (thaï)
Български (bulgare)
Čeština (tchèque)
Dansk (danois)
Deutsch (allemand)
English (anglais)
Español - España (espagnol castillan)
Español - Latinoamérica (espagnol d'Amérique latine)
Ελληνικά (grec)
Italiano (italien)
Bahasa Indonesia (indonésien)
Magyar (hongrois)
Nederlands (néerlandais)
Norsk (norvégien)
Polski (polonais)
Português (portugais du Portugal)
Português - Brasil (portugais du Brésil)
Română (roumain)
Русский (russe)
Suomi (finnois)
Svenska (suédois)
Türkçe (turc)
Tiếng Việt (vietnamien)
Українська (ukrainien)
Signaler un problème de traduction
and I need to be able to haul a lot in one trip, without sacrificing handling and flip-resistance. I like your PV-6 vehicle, but it just can't carry enough cargo.
As for the wheel issue I found a possible workaround. Jack it up on the pistons and then set the suspension to full out (-32cm) and it should then allow you to add a wheel. I ran into that same problem with not being able to weld those 2 blocks behind the wheel but then not being to place the wheel afterwards. Hope this helps!
Wheels: Unfortunately that seems to be oversight from Keens part. Some months ago they added the possibility to add blocks closer to wheel and of course I had to update this blueprint back then as it looked much nicer that way. This was never however updated to how projections work. You should be able to replace those two blocks per wheel manually after the wheels are built.
Connectors: For these vehicles with bottom connector, I use the setup you can see in the 2nd screenshot. Connectors in the middle surrounded by blast door blocks. Though there's also a small annoyance with the connectors. When I designed these vehicles it worked flawlessly, but in some update the behavior of connectors was changed and now the connector can cause this weird "locking effect" (even if they are turned off) when trying to park the vehicle.
Two things though. When I print it, I cannot add the wheels without removing two blocks per wheel that I can't replace later. Also, how do you recommend placing connectors in the vehicles' parking spaces? I use a flush floor connector and drop the trucks' suspension all the way down but that doesn't seem right.
I'm also thinking of putting DAS on board
Keep up the good work and congratulations on having Keen use your designs and world in its trailer.