Portal 2

Portal 2

516 vurderinger
Red Planet Outpost
   
Utmerkelse
Favoritt
Favoritter
Fjern som favoritt
Filstørrelse
Lagt ut
Oppdatert
140.556 MB
7. mai kl. 14.30
30. mai kl. 17.03
2 endringslogger ( vis )

Abonner for å laste ned
Red Planet Outpost

Beskrivelse
A portal 1 styled mars base for PMaM's "Redemption Arc" competition
Ranked third place :D

Credits:
https://gamebanana.com/mods/download/7271# - skybox
distantjetlines - Portal 1 material remake
Adakam - underground vents
ThatAlex14 - weathered rtx observation walls
Orlando2303#2346 - Wallpipe set

Portal Mapping and Modding Discord, aka PMaM:
https://discord.gg/qvUQHgtePd
16 kommentarer
mostlydaniel  [skaper] 9. juni kl. 22.19 
There are 2 solutions, the one you found isn't the one I intended for but it does seem to be the more popular solution. They're not that different though so it doesn't really matter
Emera Alcanterata 9. juni kl. 19.55 
There doesn't seem to be a need for laser cubes, and the end point doesn't seem to require an additional portal surface
Rooke 8. juni kl. 13.44 
Very good and good looking map, and simple puzzle. Great looking skybox!
Enjoyed! :steamthumbsup:
Anachronistic ALLOS 26. mai kl. 4.19 
Perhaps an alternate solution to the cube getting stuck (which, yes, I saw happen too when I played) is to change when the dropper closes. It looks like you set it to close a specific amount of time after the cube spawns, regardless of whether or not it escapes the tube--you could either increase this time limit, or set up a trigger_multiple to open the tube when the cube gets near, and have it only get enabled right after the cube is spawned and disabled when the cube leaves its volume.
PDX 21. mai kl. 12.57 
Puzzle was on the easy side. The aesthetics worked well. I really felt like I was on a mars base. Enjoyed it
quatrus 16. mai kl. 15.30 
Nice look for the map - thanks for creating
Fuku Yamama 14. mai kl. 19.47 
I didn't get stuck this time! Nice looking map.
PhilFromFrance 13. mai kl. 14.27 
Nice but sometime the cube gets stuck under the dropper (reverse gravity ?)
SubDuck44 12. mai kl. 10.14 
upon further investigation i found that it hits the opposite end of the tube before falling down the dropper, which causes it to not clear it in time and get stuck
SubDuck44 12. mai kl. 10.13 
i think its because of the lower gravity
it doesnt have enough time to clear the dropper and gets stuck in its little mandable-thingies