Portal 2

Portal 2

516 arvostelua
Red Planet Outpost
   
Palkinto
Lisää suosikkeihin
Lisätty suosikkeihin
Poista suosikeista
Tiedostokoko
Julkaistu
Päivitetty
140.556 MB
7.5. klo 14.30
30.5. klo 17.03
2 muutosilmoitusta ( näytä )

Tilaa ladataksesi
Red Planet Outpost

Kuvaus
A portal 1 styled mars base for PMaM's "Redemption Arc" competition
Ranked third place :D

Credits:
https://gamebanana.com/mods/download/7271# - skybox
distantjetlines - Portal 1 material remake
Adakam - underground vents
ThatAlex14 - weathered rtx observation walls
Orlando2303#2346 - Wallpipe set

Portal Mapping and Modding Discord, aka PMaM:
https://discord.gg/qvUQHgtePd
16 kommenttia
mostlydaniel  [tekijä] 9.6. klo 22.19 
There are 2 solutions, the one you found isn't the one I intended for but it does seem to be the more popular solution. They're not that different though so it doesn't really matter
Emera Alcanterata 9.6. klo 19.55 
There doesn't seem to be a need for laser cubes, and the end point doesn't seem to require an additional portal surface
Rooke 8.6. klo 13.44 
Very good and good looking map, and simple puzzle. Great looking skybox!
Enjoyed! :steamthumbsup:
Anachronistic ALLOS 26.5. klo 4.19 
Perhaps an alternate solution to the cube getting stuck (which, yes, I saw happen too when I played) is to change when the dropper closes. It looks like you set it to close a specific amount of time after the cube spawns, regardless of whether or not it escapes the tube--you could either increase this time limit, or set up a trigger_multiple to open the tube when the cube gets near, and have it only get enabled right after the cube is spawned and disabled when the cube leaves its volume.
PDX 21.5. klo 12.57 
Puzzle was on the easy side. The aesthetics worked well. I really felt like I was on a mars base. Enjoyed it
quatrus 16.5. klo 15.30 
Nice look for the map - thanks for creating
Fuku Yamama 14.5. klo 19.47 
I didn't get stuck this time! Nice looking map.
PhilFromFrance 13.5. klo 14.27 
Nice but sometime the cube gets stuck under the dropper (reverse gravity ?)
SubDuck44 12.5. klo 10.14 
upon further investigation i found that it hits the opposite end of the tube before falling down the dropper, which causes it to not clear it in time and get stuck
SubDuck44 12.5. klo 10.13 
i think its because of the lower gravity
it doesnt have enough time to clear the dropper and gets stuck in its little mandable-thingies