Subscribe to download
DR-1A DMU Head car

Real regional passenger diesel train in belarusian railroad

Recommended to enable LOW Physics!

It is advisable to turn off damage to vehicles since you will still be playing in a creative mode (come on, what normal person would spawn this in a career?)

Trailer carriage => https://steamproxy.net/sharedfiles/filedetails/?id=3043104989
Tail section => https://steamproxy.net/sharedfiles/filedetails/?id=3043105736

---

If you do not want to assemble the train manually, there is already an assembled version.
https://steamproxy.net/sharedfiles/filedetails/?id=3043129695

---

History
The first DR1 was created in the 60s in the at the Riga carriage factory (RVR). An example was the Hungarian DMU D1.
Over time, many modifications of the Riga Diesel were produced: DR1M, DR1P, DR1A and DR1B with a new cabin.
DR1A was designed in 1976. The main difference was that the train's generator could work as a starter.
Currently it is operated in Ukraine, Belarus, Latvia, Lithuania, Estonia, Russia, Georgia, Kazakhstan and Tajikistan.

---

https://steamproxy.net/sharedfiles/filedetails/?id=2879114743&searchtext=

---

How to Start!

1. Spawn head car and toggle all flip switches in the electrical cabinet and push button "take control" (it is behind the driver).
2. Release Hand brake and push "Start 1".
Wait until the diesel starts (during a cold start this may take some time)
3. Turn on in correct lights (It depends on what track you are on, in which direction you are moving and what time of day.)
4. Sit in the driver's seat and move the reversing handle forward. (up/down reversible handle control)
5. Move the brake lever all the way forward, it is to the right of the driver (a/d).
6. Turn the throttle handle clockwise to position 1 - it s idle, it is to the left of the driver (w/s).
7. Add gas a little at a time and smoothly drive out of the hangar, then stop - press button "d" 2 three or four times and the train will stop.
8. Spawn the carriage. https://steamproxy.net/sharedfiles/filedetails/?id=3043104989
9. If desired, they can be connected with a cable.
10. To move backward, remove the gas and move the reverse handle back - "down" button.
11. Spawn the next car or complete the train by spawning a tail motor car. https://steamproxy.net/sharedfiles/filedetails/?id=3043105736
12. Launch the tail section in the same way as the first, except that you do not need to press the “take control” button. !!! DON'T FORGET THE HANDBRAKE!!! You can also start or stop the engine of the tail section while in the head section by pressing the "START 2" button

Congratulations!!! The diesel train has been successfully assembled.

To change controls, just press (sometimes press twice) “Take Control”.

---

Information for nerds.

On/Off composite outout nodes

17 - Right Doors
18 - Left Doors
19 - Cabin Lights
20 - Heater

---

Please report any bugs so I can fix them.

Yes, this is a real train from Half-life 2. :)