Subscribe to download
2TE126 A

This train is not a complete replica of the real 2te126. Since in real life this train was built in just one copy.
Imagine that this train entered the series and a relatively modern control panel was installed on it.


First, you must turn on all the flip switches in the engine room and on the panel above the exit in the cockpit (the "vigilance" flip switch enable is not necessary).

Release the Parking brake, it is behind the assistant driver's seat.

Further, in order to start the diesel, you need to turn on the "fuel pump" toggle switch and hold down the Start Engine button until it starts.

!!!!!!! At startup, the "Start-Stop / Run" toggle switch must be turned off and for work you need to turn it on, you also need to turn on the "generator exication" toggle switch.

Almost ready. Next, in order to go, you just need to turn on the "take control" toggle switch, which is located under the table in the middle. Use Up/Down to control the reversible handle.




To connect, you first need the second section itself
https://steamproxy.net/sharedfiles/filedetails/?id=2952502623
After you left the hangar on the first section, put another section behind it and dock with it, then you need to connect all the hoses and cables between the sections (there are only three of them), you can find the cables themselves directly near the connector and there are also spare ones in machine room in the closet.

Start the second section in the same way as the first

Well Done, the sections are docked, now you just need to take control in one of the cabins, And do not forget to turn off this toggle switch when you are going to change the cabin.

You can also connect an infinite number of trains.

!!!The "Reverse Inverter" toggle switch is needed if you attached the second section back to front i.e. if the cabin of the second section faces of the back of the first section.!!!



Recommend using custom EMD 645 engine sound (replace middle engine)
https://steamproxy.net/sharedfiles/filedetails/?id=2915965170

I also used this microcontroller: Customizable LUA Dial Display for 1x1 Monitors
https://steamproxy.net/sharedfiles/filedetails/?id=2889223793