Butikksiden
Stormworks: Build and Rescue
Alle Diskusjoner Skjermbilder Kunstverk Kringkastninger Videoer Workshop Nyheter Veiledninger Anmeldelser

Stormworks: Build and Rescue

Butikksiden
Stormworks: Build and Rescue >  Workshop > Workshopen til MrNJersey > NJ 1x1 Temp Control Panel
NJ 1x1 Temp Control Panel
Beskrivelse Diskusjoner0 Kommentarer10 Endringslogger
10 kommentarer
< >
direwolf_20002 22. sep. 2024 kl. 12.57 
Never mind, The inside temp probe needs to be in the same room as the heating element.... I didn't expect that to be a thing.
direwolf_20002 22. sep. 2024 kl. 12.29 
Is there a limit to how much logic can be on a creation? I added this to my build, everything is connected, yet it just stopped activating and refuses to activate the heating element
LeTashie 21. juni 2024 kl. 12.33 
Nice creation! Used there: https://steamproxy.net/sharedfiles/filedetails/?id=3272412141
Something 13. juni 2022 kl. 19.45 
I have everything set up correctly, even the temps, but for some reason the heater just maxes out.
kitsuツ 14. des. 2020 kl. 1.30 
JUST, HOW?
kitsuツ 14. des. 2020 kl. 1.30 
Bruh, How, You made a frickin air conditioner more intresting then most high quality aircraft on the workshop, WOW
Pierre-Luc 28. nov. 2020 kl. 7.18 
Ah I see, thanks, will fix it :)
MrNJersey  [skaper] 28. nov. 2020 kl. 1.16 
Your temp sensor is to close to the heater. Because it’s adding +1 to the outside temp, if the outside temp is the inside then it will keep adding.
Pierre-Luc 27. nov. 2020 kl. 17.50 
Hey there, not really sure if it works properly or if I didn't set it up properly but when you press + to increase temperature it sends the heaters to full power even though it's just +1. Is it normal?
sevy 12. nov. 2020 kl. 16.37 
Hi