Подпишитесь, чтобы загрузить
Apollo(modless)

Please open this blue print in a world with indestuctible block!!!!!!!!!



270m long
115m wide and height
16 hangar
8 large reactors
4 refinery, 16 assembler. All equiped with productive module.
144 large tank.
20 gatling turrets, 16 missle turrets.

All light armor.

Done with no mod.

HOW TO CONTROL THIS SHIP:

You should see four seats on the bridge.

Blue, red, yellow and brown.



BLUE one is the main control seat.

BLUE_PAGE 1
1~8. Group 1~8 gyro override control on/off;
9. Jump drive



RED one control all jump drive and oxygen system

RED_PAGE 1
1,3,5,7. Group 1~4 jump drive recharge on/off;
2,4,6,8. Group 1~4 jump drive protection hangar door open/close;

RED_PAGE 2
1~4. Group 1~4 oxygen generator on/off;
6. Oxygen tanks on/off;
8. All turrets on/off



YELLOW one control all the lights , reactors and antenna

YELLOW_PAGE 1
1.Bridge lights on/off;
2.Energy and production area lights on/off;
3.Living area lights on/off;
4.Hangar lights on/off;
5.Main tunnel lights on/off;
6.Top desk lights on/off

YELLOW_PAGE 2
1.Top desk gravity on/off;
2.Energy and production area gravity on/off;
4~7.Group 1~4 reactors on/off;

YELLOW_PAGE 3
1.All antenna on/off;
2.Increase antenna broadcast range;
3.Decrease antenna broadcast range;
4.Antenna broadcast on/off;
5.Show ship name on/off;
7.Beacon on/off;
8.Increase beacon range;
9.Decrease beacon range



BROWN one control all hangars

BROWN_PAGE 1
1.All hangar door open;
3.All hangar door close;
5~8.Group 1~4 hangar door open/close;

BROWN_PAGE 2~5
1.Hangar camera;
2~5. Hangar door open/close;


【I watched the vedio from last stand gamer, so, here is the instruction of that 3D printer~

3D_PRINTER

1.extend the piston by pressing the 3rd button.
2.open the projector by pressing the 2nd button.
3.open the welder by pressing the 1st button.
4.reverse the piston by pressing the 3rd button.
】

Hope you like this ship! If there is any question, just leave a message and I'll reply~