Abonează-te pentru a descărca
Subworks Passive Sonar Waterfall Display

---

• Custom Baffles
  
• Optional noise simulation. Noise increases with vehicle speed and decreases with depth.
  
• Contact designation for outputting contact bearing and elevation
  
• Time interval selection: 30s, 90s and 15min intervals.
  
• Southlock option for better orientation

The Fluid meter is used to check if the sonar is in water or not. Outside of water, it will not work.
Signal to Noise Ratio property changes the density and Brightness of the simulated noise. If you don't want the noise to increase with vehicle speed, just disconnect the speed sensor.

Works on any Monitor size, however I do not recommend using it on a 1x1 Monitor due to the small size of it. Furthermore, when using it on larger or multiple monitors, I recommend turning off the noise simulation because it can cause significant lag.

---

Check out the Active Sonar Display as well:
https://steamproxy.net/sharedfiles/filedetails/?id=3074577485

Hope you enjoy, feel free to ask questions, report bugs or just give feedback in the comments!


11/08/23 - Fixed Issue where contact is not drawn on screen when it's near the edge of the monitor. Added optional Noise Simulation
07/16/24 - Added compensation for different orientations so that bearing angles stay accurate when rolling / pitching, etc. Also removed the speed sensor and compass and replaced them with a physics sensor.