Συνδρομή για λήψη
3D Runway display for Carriers

HUD display system prepared for runways that change their position, such as on aircraft carriers,
System consists of two elements:
Transmitter on the carrier that determines the position of the runway.
Receiver in the vehicle that automatically makes corrections and displays them on the HUD screen.

If the airport is outside the hud, you'll see a little arrow in the corner pointing you in the direction of your destination.

it is possible to use it for normal airports, in this case you should either prepare the transmitter at the airport or enter its coordinates directly into the vehicle. For this purpose, 3 coordinates are used to define the width and length of the runway and 2 heights are used to define the pitch

in the microcontroller settings, adjust the size of the hud and the distance from the pilot's seat, otherwise seen image may not align with runway

navigation arrow and runway lines are displayed only after receiving the required coordinates, if the plane is out of radio range or transmitter is not working properly display will not work

Version 1.01
-minor fixes in the runway display, the perimeter line and arrow will disappear after landing
-added possibility to move "plane" forward


Special thanks to Tajin for allowing me to use his "*LUA* HUD projected 3d waypoint or target" code as a base.
please check his work as well:
https://steamproxy.net/sharedfiles/filedetails/?id=1770088584