This guide is about how to make an aircraft carrier as shown. It won't be able to be placed in water.

Step 1: Your square foundations going up and down should be as long as 26. Going side to side would be around 5.
Step 2: You know how they have pins in bowling and their positions? Your foundation triangles should look how they sort the pins in bowling. Do it on both ends and don't connect them to the aircraft body. make it 1 foundation block away from the body of the carrier.
Step 3: Connect both sides and in the middle of your connection, you should have it 3 square foundations.
Step 4: On the ends of both sides, you place a foundation triangle facing to which way left side or right. Then you connect another foundation triangle to the one facing left side or right. do that on the 2 sides on each side of the carrier. so the equals to four times you have to do it.

Step 5: Follow that for the sides and make the sides 2 concrete walls tall. Then do the some thing for the floor the same as the foundation.

Now you finished making the lower part of the aircraft carrier! Congrats!

Step 6: Now for your place where the driver is.
Step 7: I'd suggest that you should have your driving area about 4 walls tall. The first one should have a door.
Step 8: For the second floor, I think you should make it glass facing where you put your door.
Step 9: For the third floor, you have it concrete because the 4 floor (The driver's place) will be glass walls all around.
Step 10: For the fourth floor you have an extra floor than the other three floors. So it's like another part of the box was added. You already know that all the walls should be glass.
Step 11: I'd suggest you use a metal table and put a monitor (on mode) on the left side of the driver. Then you get a lever and put it on nearby the monitor. Lastly, you add 3 small future container 3 under the table.

Your all done! It's as easy as saying "Piece of cake!"

- Flame Thrower55

Now that you're done, your craft should look like this: