訂閱以下載
Simple O2 Tank Level Check - ReFill

A simple script that Checks the O2 % full level of a tank(s) in a group name and if too low starts the O2 Generator(s) in a group until the tank is at a set % full level.

Using this will help keep your Cryo Pods and buildings liveable, especially if you keep opening doors and letting the air out ! No more gasping cause you forgot to turn on the generator to fill the air tank.

Helps you save power too! Generators wont run if not needing too. Also handy for air locks you build to leave space in the tanks to pull the air into.

Currently set for engage at lower than 25 % and disengage at 75 % filled.

Setup.......

Place your Tank, your O2H2 generator and your programing block.

Put the Tank(s) in a group named "O2Tanks" without the quotes

Put the O2H2 Generator(s) is a group named "O2Gens" without the quotes

Load the script into the programing block.

And off it goes. if your missing a group etc it will let you know in the status side bar of the programing block.

NOTE - If you have multiple Tanks in the group, it triggers only when ALL the tanks are below the threshold percentage and stops when ALL tanks are at the cut off level.

To Do - Separate Hydrogen Script DONE

Script generated with the online Visual Script Generator for Space Engineers at

http://dco.pe/vsb/

Hydrogen version here - https://steamproxy.net/sharedfiles/filedetails/?id=2381230557