Firstly you will need TWO - Block 4x8. Attach them length ways together.

This is your main frame of the plane

Now click the ICON with TWO COGS on the bottom left and add the Rotating Servo to any corner of the Main Frame













Now you have done that. Do the same to every corner of the main frame until all four corners have got servo's on them










Now that you have added all the rotating servo's next is the wings.
Bottom Left press the Plane icon and select the BIG WING. there are TWO types of wings. Big and Small. there are differences between the two with more/less lift but for this guide we will use the BIG WING. Add the BIG WING to each of the Rotating servo's. on the end of each BIG WING there are two connection points, add the connection points to the two connection points on the bottom of the servo's on all four corners

Now you have the Main Frame, Servo's, WIngs added.
Now go ahead and add a seat. for this guide we will use the big "default" seat. which has FOUR CONNECTIONS add the seat to the middle of the design. (Two connection points on the Block 4x8 and Two connections on the other Block 4x8)










Now go bottom and press the propulsion tab and add two dragon engines. One in front and one behind the eat (Check picture above)

Next go bottom left and press the plane icon again and this time add a powered tailfin and add it behind the back dragon engine












Next Step: Click the front right servo and press the Settings/Cog wheel











Now we have to make the back of the wing point down. so look at the Red/Green arrows next to the servo to see what direction they will go with the Hot keys you assign. For this guide i have assigned S to make the back of the wing go down (Check image)









Remember to do this for all the remaining servo's.
Front of the Main Frame - Back of the wings go DOWN
Back of the Main Frame - Back of the wings go UP









NOW YOU HAVE DONE THIS. YOU ARE READY TO FLY