Mağaza Sayfası
Stormworks: Build and Rescue
Tümü Tartışmalar Ekran Görüntüleri Çizimler Yayınlar Videolar Atölye Haberler Rehberler İncelemeler

Stormworks: Build and Rescue

Mağaza Sayfası
Stormworks: Build and Rescue >  Atölye > Chickensaur Kullanıcısının Atölyesi
Yeterli oy yok
Auto-Anchor
Açıklama Tartışmalar0 Yorumlar4 Değişiklik Notları
   
Ödül
Favorilere Ekle
Favorilere Eklendi
Favorilerden Çıkar
Vehicles: Sea
Microcontrollers: Microcontroller
Etiketler: v1.11.8
Dosya Boyutu
Gönderilme
Güncellenme
19.205 KB
16 Tem 2019 @ 1:00
11 Ağu @ 15:50
2 Değişiklik Notu ( görüntüle )
Oluşturan
Chickensaur
Çevrimdışı
Chickensaur ve diğer kişiler tarafından oluşturulmuş 11 koleksiyona göz atın (bazıları gizli olabilir)
1,088 Tekil Ziyaretçi
665 Mevcut Abone
10 Mevcut Favoriler

İndirmek için abone ol
Auto-Anchor

Chickensaur tarafından 1 koleksiyonda
Chickensaur's Contraptions
45 öğe
Açıklama
To Setup:
Connect "Toggle Up/Down" input node on the controller to a toggle button.
Connect "Is Mag-All Connected" input node on the controller to the "Connected" output node on a Mag-all.
Connect "Cable Length of Winch" input node on the controller to the "Cable Length" output node on a winch.
Connect "Cable Up" and "Cable Down" output nodes on the controller to their respective input nodes on a winch.
Connect "Magnet Toggle" output node on the controller to "Magnet Toggle" input node on a Mag-all

Parameters:
Idle height: Length of the Cable when the Anchor is up
Deadzone: Cable length before which the mag-all will not be on. Eg if Deadzone is set to 3, the mag-all will not turn on until the winch unwinds 3.1m. Set this high enough to prevent the mag all attaching to your own hull, but low enough so it grabs the ocean floor once it has cleared your hull.

Note Mag-All Connected and Mag-All Connect signals MUST BE sent through the winch. Example

Everything of mine that isn't a collab is free to use and re-upload, credit is appreciated but not necessary. Enjoy!
4 Yorum
< >
Chickensaur  [yaratıcı] 20 Nis 2022 @ 18:51 
it should stop doing that automatically, ensure the connected signal is getting to the MC, it needs to be run into the cable anchor and out the winch
The Derper 20 Nis 2022 @ 18:50 
Is there a way to make it so the winch will stop letting out cable once the magnet connects to something?
ecwskier 24 Şub 2021 @ 14:15 
how do i send the connected on the mag all through the winch
LittleGroove 19 Ara 2020 @ 2:19 
Works great, using this for a deep sea anchor that hides under a sealed door, able to have it open the door when up or down is on for the MC and lock the door when its closed so Im happy to see logic work out super easy in this case to add things onto it