Stormworks: Build and Rescue

Stormworks: Build and Rescue

No hay suficientes valoraciones
Thunderbird 1 [Release!]
   
Premiar
Favoritos
Favorito
Quitar
Tamaño
Publicado el
Actualizado el
866.129 KB
17 ABR 2018 a las 13:36
27 ABR 2018 a las 21:13
3 notas sobre cambios ( ver )

Suscríbete para descargar
Thunderbird 1 [Release!]

Descripción
This is Thunderbird 1.

CONTROLS ARE NOW LISTED IN THE SEAT,

Startup Procedure:

Board aircraft.
Prime Systems and Start Engines
Wait 2 seconds, activate altitude hold.
Stow Landing Gear
Press W to fly out of the hangar.

This project took months to complete, but due to a recent update, the base of the design started to work.
Maximum speed is around 38 m/s.

Very proud of this.

If the back segment does not rotate, it's a bad spawn. Nothing I can do about it. Respawn the vehicle. It also has a tendency to flip sometimes, depending on how you fly. Don't raise the landing gear before you are in the air. It will cause the aircraft to flip.

NOTE: It cannot take-off at 60%+ winds.
19 comentarios
SCP 7 AGO 2021 a las 15:01 
@Felexl It's broken, that's why.
Felexl 5 AGO 2021 a las 7:12 
u cant get in it
SCP 28 FEB 2021 a las 12:00 
It's broken unfortunately
glitchy_red24 27 FEB 2021 a las 13:56 
it wont start for me
Ghost  [autor] 24 FEB 2021 a las 21:31 
I badly want to try the TB1 from the new series, but I’ve caught myself up with another project.
joe_frearson 21 FEB 2021 a las 2:20 
I had a go and tried to get it near the cgi series one so it was more useful and could do more but i couldn't get the flight figured out, I used jet engines though. I've been meaning to try these fans but powered by jet engines but haven't gotten around to it yet.
Ghost  [autor] 7 NOV 2020 a las 12:51 
This would need a complete redesign. I love TB1, but not so sure about this rendition of it anymore.
almil53 6 NOV 2020 a las 21:02 
do you ever plan to try to remake thunderbird 1 to be able to work with the latest update?
SCP 17 MAY 2020 a las 9:40 
I have done more research and testing, after a few "modifications", I have found that it isn't actually the landing gear, but one of the fans inside. After completely "removing" the back landing gears, TB1 still pushed itself over onto its side because of a fan breaking and causing it to freak out. I am guessing an update caused this issue to occur so fans cannot be used.
SCP 8 MAY 2020 a las 10:46 
I believe I found the issue, on spawn, one of the back landing gears doesnt rotate correctly and causes it to flip on spawn, land or water, this is an issue, as later on, it clips into the hull and causes it to spin out of control, well, thats what I think is going on. I am not a "build" guy so if anyone can fix that, that would be greatly appreciated