Steamをインストール
ログイン
|
言語
简体中文(簡体字中国語)
繁體中文(繁体字中国語)
한국어 (韓国語)
ไทย (タイ語)
български (ブルガリア語)
Čeština(チェコ語)
Dansk (デンマーク語)
Deutsch (ドイツ語)
English (英語)
Español - España (スペイン語 - スペイン)
Español - Latinoamérica (スペイン語 - ラテンアメリカ)
Ελληνικά (ギリシャ語)
Français (フランス語)
Italiano (イタリア語)
Bahasa Indonesia(インドネシア語)
Magyar(ハンガリー語)
Nederlands (オランダ語)
Norsk (ノルウェー語)
Polski (ポーランド語)
Português(ポルトガル語-ポルトガル)
Português - Brasil (ポルトガル語 - ブラジル)
Română(ルーマニア語)
Русский (ロシア語)
Suomi (フィンランド語)
Svenska (スウェーデン語)
Türkçe (トルコ語)
Tiếng Việt (ベトナム語)
Українська (ウクライナ語)
翻訳の問題を報告
dlatch(x,s) =
y = if s then x else max(y,y)
single circuit version:
y = if s then x else y
AND : A * B ( MIN(A,B) works also )
OR : MAX(A,B)
XOR : A != B ( != means "not equal" )
NOT : 1 - A (this one uses an additional memory chip to store 1)
Just one improvement about the AND gate.
Test (a+b) == 2
While this is certainly correct, it needs a math processor to add a and b, followed by a compare processor, to compare(equals) the sum with a "2" from memory.
It can also be done with just one math processor set to multiply.
0*0=0
0*1=0
1*0=0
1*1=1
Compare(equals) the result to "0" from memory, to make it a NAND gate.
An "equals 0" compare operation would also work, which is probably a more intuitive solution.
I've been thinking all day about writing article like that)
Just went to the manuals page to see if its written by someone...
And thats it) Good job Hardly. I wish you will not stop, so I don't have to write manuals)