Підпишіться, аби завантажити
flatbread

Attention: Anyone is allowed to modify my vehicle and upload it as long as you credit me as original author. However, please do not copy it or simply change its paint and reupload, the workshop is quite crowded with those. Please and thank you :)

I did not base this creation on anything in particular. My friend (just joking its me) and I had a Brick Challenge to build ourselves a flatbed truck and carry a vehicle of ours an entire loop around the canyon map. Both of our vehicles turned out well. Credit to "just joking its me" for the bed, actuator, and winch setup. Mine is strongly based on his.

Anyway, to properly operate, lower the ramp completely and either drive up it or pull your car in with the front winch. Attach the rear winch and tighten both for secure and safe travel. Finally, and most importantly, retract the bed BEFORE raising it to horizontal again otherwise you risk snapping it off.

Alt Throttle is extend/retract bed. Alt Pitch is change angle of bed.

I hope you enjoy tuggin things around on it!