In order to configure your controller binds, you'll need to have Steam overlay enabled. You can shift+tab or press the home button on your controller to access the menu. From there, just click on "Controller Configuration" on the left-hand side.

Changing keybinds is different from the usual. Instead of assigning a button to an action, you'll be assigning an action to a button.

In this example I am using a PS4 controller, but the configuration should be essentially the same. You can select the team you want to adjust by going into one of the three controls at the top. I am just going to go through shark controls as an example.



If you don't like the button binds, you can change the action bound to the button by clicking on its current actions.



Once you get in, you can change the action assigned to the button(s) by clicking on them and assigning a new action.






Likewise, you can unbind a button by assigning the button to no action.

Autosprint can be a problem for stamina management, but it can be changed in a number of ways.

First you'll need to go into the action assigned to the left joystick.



From there, you can open up "Advanced Settings" at the bottom of the screen.






If you would like the joystick to have to be pressed in order to sprint, you'll need to assign "Sprint" to the "Click Action". Or you can assign it to any other button on the controller.



Then you will need to remove "Sprint" from "Outer Ring Binding".






If instead you want to keep the autosprint but increase / lower the threshold, go into "Additional Settings" on the bottom right-hand side.



On the right-hand side you can change the point at which sprinting begins. A higher outer ring radius means that you will have to move the joystick closer to the edge in order to start sprinting.